Table of Contents
'ODROID-SHOW2' device
Parameters
| Parameter | Value |
|---|---|
| Bauds | 500000 |
| Parity | None |
| Data bits | 8 |
| Stop bits | 1 |
All other parameters are OFF.
Under 'Windows'
Under Windows, to configure the serial port correctly, launch mode com<n> 500000,n,8,1, where <n> is the serial port number (launching mode displays the available ports).
It seems that above command sets some parameters to ON, but it seems not to matter…
Under 'GNU/Linux'
Under GNU/Linux, to set the parameters for this device, launch stty -F /dev/ttyUSB<n> 500000.
Firmware compilation
Following instructions concern the Arduino IDE.
- First, launch
git clone https://github.com/hardkernel/ODROID-SHOWin a console, - Click on
ODROID-SHOW/show_main/show_main.ino(should have be created by above command) ; this should launch the Arduino IDE, File/Preferences/Settings/Sketchbook location:: set it to the aboveODROID-SHOWdirectory,Sketch/Import Library/Add Library…/: point to aboveODROID-SHOWdirectory.